[ad_1]
After admiring Julie’s picket pegboard from Germany (as seen in Remodelista: The Organized Residence), I hinted to my husband, Chad, that it might make a beautiful Christmas current. He, being a woodworking hobbyist, determined it might be simpler to make one himself.
Not fairly.
With out instructions or pointers, designing and executing a pegboard in order that the whole lot strains up cleanly takes loads of thought. Thankfully, my husband has completed the be just right for you. Chad now has three such boards below his belt. Complete time to make one? About 4 or 5 hours. Not simple, however undoubtedly doable in sooner or later.
Right here’s Chad’s how-to.
Provides
Wooden and {hardware}
- ¾-inch thick birch plywood (roughly 24 by 48 inches) for pegboard or base
- ½-inch thick birch plywood (roughly 24 by 48 inches) for cabinets
- 4-to-6¾-inch thick oak wooden dowels (roughly 36 inches lengthy) for pegs
- 1-inch wooden screws for cabinets
- 4 lengthy (1¾ inch) wooden screws to screw the backboard into the wall studs
Instruments
- desk noticed
- chop noticed
- drill
- countersink drill bit (No. 6)
- bench vise
- drum sander
- hand sander
- belt sander
For a extra handbook strategy, you would use a round noticed and hand noticed, however these instruments would make it exhausting to attain even edges.
Step 1: Sand base board.
To create a clean floor, calmly sand the sides of ¾-inch plywood base.
Step 2: Create template.
[ad_2]
Source link
