[ad_1]
I nonetheless don’t have any of the partitions in the principle a part of our grasp lavatory fully completed, however I’m making good progress on them. I shared the primary a part of this venture a few weeks in the past. For those who missed that submit, you could find it right here: DIY Wainscoting Half 1 — The Anatomy Of Choose’s Paneling With Tile Accent (Toilet Partitions). Right here’s what the essential design of that wainscoting appears like. The band of plywood is the place the accent tile shall be added, and the remainder of it will likely be painted stable white.
Now that the counter tops have been put in, I’ve been engaged on carrying that wainscoting over to the opposite facet of the door, and wrapping it across the countertop. And hoping and praying that I did all of my planning and calculations appropriately in order that it might move from one facet of the door to the opposite facet, and wrap across the countertop as a backsplash, repeatedly and flawlessly.
For those who’ll bear in mind, just under the plywood strip that may act as a backer for the accent tile, I added a strip of wooden (it began as a 1″ x 2″ piece of lumber, and I ripped it down into 3/4-inch-wide strips), after which added an ornamental trim on high. The entire objective of this strip was to take up the width of the countertop that may be put in on the opposite facet of the door. In different phrases, that 3/4-inch strip would useless finish into the sting of the three/4-inch-thick countertop.
After which on the areas the place there isn’t a countertop, the accent tile shall be put in simply above that trim. However across the countertop, the tile will sit proper on the countertop with none trim beneath.
If that’s clear as mud, I now have a visible that I hope will clear issues up for you. You’ll be able to see within the photograph beneath how that 3/4-inch trim runs proper into the sting of the countertop. However the plywood (which, once more, is the backer for the accent tile) runs repeatedly across the wall and proper on high of the countertop to create the tile backsplash.
(FYI, for these of you confused in regards to the door, it got here with the panes lined in plastic and pre-primed. So all of that primer is on the plastic, which is well lower away after the door is painted.)
Right here’s one other have a look at it wrapping across the nook and underneath the mirror.
After which I continued on with the remainder of the wainscoting elements to complete off all the trim element. Once more, when you missed the submit the place I went over all the particulars in regards to the trim items that have been used, you’ll be able to click on right here to seek out that info.
So whereas it nonetheless wants a number of ending (sanding, grouting, priming, sanding, and tiling), you can begin to see the complete design take form. And let me let you know, I breathed an enormous sigh of reduction once I noticed that every one of my calculations and measurements and planning labored out simply as they need to.
It gained’t be an excessive amount of longer earlier than I’ll have an enormous part of wall completed, and I’ll be capable to see this entire imaginative and prescient come to life.
Addicted 2 Adorning is the place I share my DIY and adorning journey as I rework and enhance the 1948 fixer higher that my husband, Matt, and I purchased in 2013. Matt has M.S. and is unable to do bodily work, so I do nearly all of the work on the home on my own. You’ll be able to study extra about me right here.
I hope you’ll be a part of me on my DIY and adorning journey! If you wish to observe my tasks and progress, you’ll be able to subscribe beneath and have every new submit delivered to your e-mail inbox. That approach you’ll by no means miss a factor!
[ad_2]
Source link
